|
After Designing and Building Certified (FDA/CDRH/IEC Compliant) LASERS for
over 25 Years,
ELK Industries, LLC has a Breakthrough LASER diode Product, along with an OEM
diode Module that can Produce 1 watt of Blue, 445 nm output.
The Technical Data for the LASER
Diode, designated the LD 2445, 1 Watt, 445 nm Device is detailed on
Our Data Sheet for the LD 2445.
The most significant breakthrough is the Low Cost of these Items. These
(standard 5.6 mm Package) LASER Diodes, type LD 2445, have a target price
of under $300 each, in large quantities, and (still) less than $400 each, in
unit quantities to OEM Qualified recipients. For the output in the BLUE @
440-445 nm, with 1 watt Output, this represents a substantial savings over the
only other existing 1 watt Blue LASERS, which, until now, are typically DPSS
Type LASERS.
In addition to the low cost LASER Diodes, the LD 2445, themselves, ELK
Industries has very low cost, complete, OEM LASER Modules, with 1 Watt Outputs
and have a Collimator to narrow the beam waist to less than 1 mm. The input to
the LASER Module is 100 - 240 VAC, at 50 - 60Hz.
Essentially, an OEM LASER Module of High Power (1 Watt) in the Blue, at 440-445
nm is the lowest cost, 1 watt LASER Module available anywhere that we are aware
of. The collimator is fixed in a position, relative to the LASER Diode in order
to decrease (dramatically) the divergence of the LASER Output from the LASER
Diode. An Additional optical assembly can reduce the divergence even further -
keeping the spot size under 10 mm, even over extended extended distances. The
Power Supply
has an adjustment to control the LASER Output Power. ELK Industries is planning
to sell these (OEM) LASER Modules for well under $1,500!
The LASER Diode LD 2445 is so very efficient, that it can operate at a
cool temperature (<27 degrees, C), at room temperature of 25 degrees, C, using a
relatively small heat sink (4" x 4" x 1"). Therefore, TEC cooling is not
required at all. The OEM Modules are very small, lightweight, rugged, and
compact, measuring 4" x 4" x 6". FDA/CDRH/IeC versions are also available from
ELK Industries, for slightly higher Pricing.
However, these Prices and Offers are for a Limited Time basis (only).
This is a Spectacular LASER with many uses; in Display Technology, Dye LASER
Pumping, LASER Ablation Spectroscopy, LASER Micromachining, Flourescence
Lifetime Studies, "RGB" Playback Systems, Optical Data storage, Control &
elimination of MRSA, and many other Micro-Organisms, and LASER Microscopy.
See attached Data Sheet and Photograph of the LASER Module, in Operation.
Contact: ELK Industries, LLC. or AAT, Inc. (American Advanced Technologies)
for more Information, or to Place an Order.
Technical Representative/Chief Scientist: Mr. Robin Elkins,
321 259-8114, LASEROB@aol.com
|
